The long-awaited new product from Hoperf is the CMT2380F32 (http://vis-plus.ee/pdf/cmt2380f32.pdf) is now available to order.
Inside the CMT2380F32 is a 32-bit ARM® Cortex -M0 microcontroller and a 127-1020 MHz transceiver.
The main parameters are as follows:
32kB Flash with write protection
4kB RAM with parity to enhance system stability
2 x UART
1 x ultra-low power UART (LPUART)
1 x I2C
1 x SPI
9-channel 12bit ADC
Frequency range of operation 127 - 1020 MHz
Supported modulation types FSK, GFSK, MSK, GMSK and OOK
Data transfer rate 0.5 - 300 kbps
Receiver sensitivity: -121 dBm @ 434 MHz, FSK
Receiver current: 8.5 mA @ 434 MHz, FSK
Transmitter Consumption Current: 72 mA @ 20 dBm, 434 MHz
Configurable FIFO buffer up to 64-byte
Power consumption 0.5 uA x 3 V (deep sleep mode): all timers are off, reset is active, waking up upon interruption of inputs, all registers, RAM and the processor remain in the data storage state
Power Consumption 0.8 uA x 3 V (deep sleep mode): RTC works
Power consumption 150 uA / MHz x 3 V in normal operation
Low power modes allow this chip to be used in stand-alone security and fire alarm sensors, telemetry devices, remote control devices, wireless data transfer devices, etc.
For more information, contact our specialists.